게시판 게시물

yibocommunal
2022년 9월 13일
In Wix 게시판 콘텐츠
When the centrifugal pump is started, it will carry out the actual operation of exhaust and water filling, which can make the machine run more effectively. So next, I'll explain the water filling and exhaust methods of this machine in detail. Let's take a look. Since the centrifugal pump generates vacuum pump and water seepage after the pressure in the pump is discharged by the centrifugal impeller, in addition to the centrifugal pump and the self suction pump with the centrifugal impeller immersed in water, it is generally necessary to fill the pump with water before starting the pump every time, which is also known as adding a diversion channel. There are two ways to fill water: one is to fill the pump immediately (at this time, the air outlet should be opened to drain the gas in the pump); The second is to pump out the steam in the pump, create a certain vacuum value (at this time, close the stop valve at the outlet), and introduce water resources. 1. Install gate valves at the inlet and outlet to fill water. This type of method is to install a gate valve at the water inlet, and then fill the pump with water after connecting the tap water pipe. 2. Fill water with hand pump. Some pumps have built-in hand pressure pumps, and small and medium-sized hand pressure pumps can also be purchased or made by ourselves. Stop valves must be installed on the inlet pipes. After closing the gate valve tightly, fill the water pressure machine with a small amount of water to carry out the diversion channel. After manually pressing the water output of the pump, it indicates that the pump is filled with water and can be started. 3. Exhaust and fill water with vacuum technology. The self exhaust of centrifugal pump is the same as the negative pressure exhaust of mechanical pump, so the water ring mechanical pump exhaust can fill the water channel. Therefore, when the centrifugal pump cannot perform the actual operation of exhaust and water filling normally, it must be repaired immediately to prevent endangering all normal applications of machinery and equipment, or it will continue to cause damage to machinery and equipment at a certain level. Calibration method of Vacuum Leak Liquid ring vacuum pump Liquid ring vacuum pump manufacturer
0
0
2
yibocommunal
2022년 9월 13일
In Wix 게시판 시작하기
There are three types of linings commonly used in modern tubular heating furnaces: brick structure, refractory fiber spray structure and castable structure.How to Update your heat treatment brick structure Brick lining is made of refractory bricks, including standard refractory bricks and special-shaped refractory bricks. The advantage is that different types, properties and grades of refractory bricks and refractory mud can be selected according to the working temperature, working conditions and heat load of different parts of the heating furnace. The disadvantage is that the integrity and sealing of the furnace lining are poor, and the construction efficiency is low.Vacuum heat treatment process of TC11 titanium alloy pipe Refractory fiber sprayed structure Refractory fiber spraying is to send the pretreated bulk fiber cotton out of the spray gun at high pressure through a special fiber spraying machine, and at the same time, through several sets of special fluid conveying equipment, the inorganic binder is evenly sprayed into the fiber cotton through the outer ring of the spray gun. The external mixture is sprayed onto the inner wall of the furnace. The advantages of refractory fiber spraying construction technology are fast construction speed, seamless lining and good air tightness, which is especially suitable for the construction of complex and special-shaped furnace walls.Vacuum heat treatment of high-speed turning tools
1
1
1

yibocommunal

더보기